Pairing an Ingenico Tetra Device using PayGuardian Cloud

This guide assumes that the Download Process outlined on this page has been completed. If this download has not taken place, please proceed to that page and return here once the download completes.

The following Postman Collection can be used to get started with the Pairing Process:

Steps

1. Turn on device after the initial download is completecompletes.

2. Tap/Press the “Settings” option (“Settings” option on the Tetra devices screen.

   1. This is located in the bottom right of the screen.

   2. Note: The TerminalID/UUID is displayed on the device

   )Image Removed

   1. on the resulting screen after pressing “Settings”. This is shown below. The UUID can be transcribed from this screen, or you can proceed to step 3 to obtain this value via the API.

      Image Added

3. Tap/Press “Pair” option

   Image Removed

   Make on the Tetra devices screen.

   1. This is located in the top right corner of the screen.

      Image Added

4. Perform the “Get Pairing Code” call (Enter your Device Name)via the PayGuardian Cloud API as defined in the linked Postman Collection

5. Enter the code returned from the “Get Pairing Code” call into the Ingenico Tetra device and press the GREEN key

   Image RemovedImage Added

6. Make Perform the “Get UUID” call (Enter the Pairing code returned in step 4)via the PayGuardian Cloud API as defined in the linked Postman Collection

   1. Your TerminalID (UUID) will be returned in this call.

   It will be used in all PayGuardian Cloud calls to this specific device

   2. Save this value for use in the PayGuardian Cloud API.